QSC DSP-4 Manual descargar pdf (Pagina 13)

Daisy Chaining

Daisy chaining the DSP-4 outputs to additional amplifiers:

The DSP-4 has two XLR audio outputs, one for each channel. These outputs may be used for daisy-chaining the post-DSP signal to other

amplifiers or for monitoring purposes. The XLR outputs may be used for daisy-chaining even when the DataPorts are used for input/out-

put. Do not use Output Power Limiting when daisy chaining.

To daisy-chain the DSP output, connect the output jacks of the DSP-4 to the input jacks of the next amplifier. Then connect

the paralleled signal from the first amplifier to the second amplifier, and so on, up to a maximum of five amplifiers (including the output

DataPort if connected to an amplifier). Make sure that all interconnecting cables are balanced and connected properly.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Sin comentarios

QSC DSP-4 Manual Pagina 13